Search results for "Alveolar ridge augmentation"
showing 10 items of 33 documents
Treatment of intrabony defects using guided tissue regeneration and autogenous spongiosa alone or combined with hydroxyapatite/beta-tricalcium phosph…
2007
The aim of this case-control study was to investigate the clinical regeneration of deep intrabony defects using guided tissue regeneration (GTR) with autogenous spongiosa (ASB) alone or using GTR with a mixture of ASB with a bovine-derived xenograft (BDX) or a synthetic composite bone substitute (hydroxyapatite/beta-tricalcium phosphate [HA/beta-TCP]).Sixty-four patients with a total of 93 intrabony defects of 2- or 3-wall morphology and an intrabony component (IC)or=4 mm participated in this study. Defects were treated with a bioabsorbable membrane and ASB alone or ASB mixed with HA/beta-TCP or BDX. Clinical parameters measured at baseline and 12 months after surgery included IC, bleeding …
Vertical Mandibular Alveolar Bone Distraction and Dental Implant Placement: A Case Report
2006
Abstract Extensive bone defects complicate the adequate placement of dental implants and the required angulation. In such cases, alveolar-ridge augmentation techniques such as guided bone regeneration, particulate or block grafting, and alveolar bone distraction are needed. The present study describes a case in which a large vertical bone defect in the anterior mandibular zone was corrected via vertical alveolar bone distraction. Six dental implants were posteriorly placed for implant-supported restoration of the mandible, with early implant loading. The clinical and radiologic control showed good implant and soft tissue conditions 12 months later.
Results of oral implant–supported prostheses after mandibular vertical alveolar ridge distraction: a propos of 54 sites
2012
Objective The aim of this study was to present retrospective long-term results of oral implant–supported prostheses after mandibular vertical alveolar ridge distraction. Study Design Patients who had alveolar mandibular distraction before oral rehabilitation from 1999 to 2009 were retrospectively reviewed. Results Fifty-four distractions were performed in 25 women and 12 men with a mean age of 51.7 years. Seventeen patients had bilateral distraction. Most of the distracted sites were posterior. Global major complications were major misdirection (3.7%), fracture (3.7%), and permanent alveolar nerve paresthesia (1 patient). All of the patients experienced osseous improvement. Mean height of t…
Mandibular connective tissue pedicle flaps in implant dentistry: report of three cases.
2007
Abstract An increase in soft tissues and alveolar bone in the anterior mandibular area between the canines is necessary to achieve a good esthetic result. The present article describes a technique for gaining bone volume and soft tissue to cover bone defects that would otherwise compromise the final result of prosthetic implant restoration in the anterior mandible. Three patients with anterior mandibular atrophy caused by loss of the mandibular incisors are presented. Particulate autologous bone grafting, the raising of a pediculate connective tissue flap to increase soft tissue, and implant placement were carried out simultaneously. After 2 years of follow-up, the implants were in good cli…
Vertical guided bone regeneration with bioabsorbable barriers.
2007
Guided bone regeneration (GBR) is a very useful surgical technique to increase limited alveolar bone for implant placement. The use of non-resorbable barriers is well established; however, bioabsorbable collagen membranes may simplify the surgical technique and make it more predictable.Vertical ridge augmentation was performed on 11 patients at the time of implant placement. The part of the implant out of bone was covered with autogenous bone/graft, and a slow-resorption collagen membrane was placed on top. Gingival tissues were closed with horizontal mattress and interrupted sutures. Second-stage surgery was performed 4 to 6 months later, and healing abutments were placed. The length of th…
Implant treatment planning regarding augmentation procedures: panoramic radiographs vs. cone beam computed tomography images.
2015
Objectives To evaluate the impact of cone beam computed tomography (CBCT) imaging on treatment planning regarding augmentation procedures for implant placement. Material and methods Panoramic radiographs and CBCT images of 40 patients requesting single-tooth implants in 59 sites were retrospectively analyzed by six specialists in implantology, and treatment planning was performed. Therapeutic recommendations were compared with the surgical protocol performed initially. Results Bone height estimation from panoramic radiographs yielded to higher measures and greater variability compared to CBCT. The suggested treatment plan for lateral and vertical augmentation procedures based on CBCT or pan…
Maintenance of Class III Trifurcated Molars Versus Implant Placement in Regenerated Extraction Sockets: Long-Term Results of 2 Cases
2011
Studies to date have reached differing conclusions regarding the long-term prognosis of teeth with class III furcation involvement. Replacement of such teeth with implants could be an alternative. This report compares the treatment outcomes of 2 cases with similar disease progression: 1 treated by implant therapy and 1 maintained with nonsurgical periodontal treatment. Two patients with advanced chronic periodontitis and class III furcation involvement of all molars were treated. Case 1 received a conservative periodontal and antibiotic treatment, followed by 15 years of maintenance. In case 2, the molars were extracted and replaced with implants, and the implants were observed for 7 years.…
Implant treatment in atrophic posterior mandibles: Vertical regeneration with block bone grafts versus implants with 5.5-mm intrabony length
2014
Purpose: To retrospectively compare the outcomes of implants placed in posterior mandibles vertically regenerated with onlay autogenous block bone grafts and short dental implants. Materials and Methods: Consecutive patients with vertical bone atrophy in edentulous mandibular posterior regions (7 to 8 mm of bone above the inferior alveolar nerve) were treated with either implants placed in regenerated bone using autologous block bone grafts (group 1) or short implants (with 5.5-mm intrabony length) in native bone (group 2) between 2005 and 2010 and followed for 12 months after loading. The procedure used was the established treatment protocol for this type of patient at the Oral Surgery Uni…
Use of buccal fat pad to repair post-extraction peri-implant bone defects in the posterior maxilla: a preliminary prospective study
2015
Background: Extensive literature exists about the use of the BFP in the treatment of oral defects but, to our knowledge, no article refers to the use of the BFP as a substitute of the membrane barriers for treatment of peri- implant bone defects. The aim was to evaluate the use of the buccal fat pad as a coating material for bone grafting in the peri-implant bone defect regeneration of immediate implants placed in the posterior maxilla. Material and Methods: A preliminary prospective study of patients involving immediate implants in which the buccal fat pad was used as a coating material to peri-implant bone defects was carried out. The outcome measures assessed were: postoperative pain and…
A new morphologic classification of the alveolar ridge after distraction osteogenesis in human patients. A 17 years retrospective case series study
2020
Background To perform a morphologic classification based on the results of bone augmentation after a distraction osteogenesis. Material and Methods Thirty-four (34) patients (24 women and 10 men; mean age, 47.1 years (SD=9.5); age range, 23 to 62 years) underwent a total of 42 alveolar ridge distractions before the placement of a total of 89 dental implants. Ridge bone morphology was evaluated as the main ordinal variable. Chi-squared, Kruskal-Wallis and ANOVA one-way test were used. Results Category I (30.95%): consisted of wide alveolar rim and no bone defects Category II (28.57%): wide alveolar rim, lateral bone surface concavity. Category III (23.81%): narrow alveolar rim, lateral bone …